Closed-cell foam sprayed onto the steel of warehouses, shops, detached garages, and horse barns in Albuquerque, Rio Rancho, and the valley. Insulation and air sealing are planned alongside panel repairs, indoor moisture and ventilation.
Schedule a VisitMetal Building Insulation in Albuquerque
Albuquerque has steel buildings of every size. Pre-engineered warehouses and contractor shops sit near the interstates, steel garages and hobby shops stand behind houses in Rio Rancho and on the West Side, and pole barns and horse barns dot the ditch-irrigated lots of the North Valley, South Valley, and Los Ranchos. They all deal with the same high-desert swing. A sunny afternoon heats the roof sheets well past the air, a clear night strips that heat away, and by sunrise the underside of the steel is cold enough to gather moisture from the air inside. Up the canyon in Carnuel and Tijeras, nights are colder and shops stay heated for more of the year.
Foam insulation for metal buildings means closed-cell foam bonded right to the back of the panels, so damp inside air has nowhere to touch cold metal. Condensation control also depends on indoor moisture and ventilation; an active roof leak still needs repair. The same coat fills the laps and screw holes that let spring dust blow in, helps stiffen light-gauge sheets. Noise depends on the complete roof and building assembly. The added rigidity depends on the product, thickness, and construction. With an older building, the steel gets checked first, since rust, flaking paint, and sagging blanket all change the prep.
For an Albuquerque warehouse, garage or valley barn, bring the intended use into the estimate discussion. A workshop with finished rooms, open vehicle bays or animals has different access and ventilation needs. We identify the panels to receive foam, existing materials to remove or prepare, and any protective coating included before work begins.
Step 1
We check the panels and what is on them now, how the building is used, and what has to keep running while we work.
Step 2
Equipment, stock, doors, and floors get covered, and the steel is prepped so the foam bonds to it.
Step 3
Closed-cell foam goes onto the roof and wall panels to the thickness in the estimate, plus any thermal or ignition barrier coating the building’s use requires.
Step 4
We go over coverage and thickness against the estimate and walk the building with you before we pack up.
Also serving: Rio Rancho, Los Ranchos de Albuquerque, North Valley, South Valley, Paradise Hills, Sandia Heights, Carnuel, Tijeras.
Our work
See our work in other communities we serve. Each gallery names the town.
Roswell, NMA clear-span steel building in Roswell with spray foam under the whole roof and down the walls, sprayed around the roll-up doors and walk-in doors.
Capitan, NMA steel building in Capitan with framed rooms inside: foam in the stud walls and ceilings of the rooms, and on the roof panels over the open bay.
San Patricio, NMSpray foam in the framed walls of a steel building in San Patricio, in the Hondo Valley, around a roll-up door, plumbing lines and a small room.
Guides
Send the footprint and eave height, a few photos, and whether the building is new or already in use, and we’ll set up a site visit.
