Photo: AllenS, Public domain (cropped)
Milk barns, oilfield yard shops, farm equipment barns, and backyard steel garages insulated with closed-cell foam, from Artesia and Morningside out to Atoka, Hope, and Loco Hills. We plan the spraying around milking times, shop hours, and trucks that keep moving.
Schedule a VisitMetal Building Insulation in Artesia
Steel does a lot of different work around Artesia. Dairies across the valley run milk barns, parlors, and shops. Farms growing alfalfa, cotton, and pecans park tractors and harvest equipment in steel sheds. East toward Loco Hills, oilfield service yards put up shops and warehouses, and in town, welding and truck shops work for the refinery and the patch. Bare panels treat them all alike: the roofs bake through summer afternoons and go cold on winter nights. In a milk barn, where washdown water and the cows keep the air damp, that cold steel sweats and drips on whatever is below.
Closed-cell spray foam insulation on metal building walls and roofs bonds to the steel and expands into laps, seams, and fastener holes, closing them against wind and field dust. With foam stuck to the panel, damp air no longer touches the cold steel, and it can help manage condensation at the panel; washdown, indoor moisture and ventilation still need a plan. It also helps stiffen thin panels. Noise performance depends on the complete assembly. The added rigidity depends on the product, thickness, and construction. In dairy and farm buildings we plan around animals, feed, and equipment before we spray. On older steel we check for rust, old coatings, and faced blanket first, since each changes the prep.
For an Artesia farm or service shop, tell us the building size and what happens there each day. Washdown areas, animal housing, vehicle bays and enclosed rooms need separate planning. During a visit or plan review, we check the panels and access, then list the insulation work and any protective coating in the written estimate.
Step 1
We check the panels and what is on them now, how the building is used, and what has to keep running while we work.
Step 2
Equipment, stock, doors, and floors get covered, and the steel is prepped so the foam bonds to it.
Step 3
Closed-cell foam goes onto the roof and wall panels to the thickness in the estimate, plus any thermal or ignition barrier coating the building’s use requires.
Step 4
We go over coverage and thickness against the estimate and walk the building with you before we pack up.
Also serving: Morningside, Atoka, Hope, Loco Hills.
Our work
See our work in other communities we serve. Each gallery names the town.
Roswell, NMA clear-span steel building in Roswell with spray foam under the whole roof and down the walls, sprayed around the roll-up doors and walk-in doors.
Capitan, NMA steel building in Capitan with framed rooms inside: foam in the stud walls and ceilings of the rooms, and on the roof panels over the open bay.
San Patricio, NMSpray foam in the framed walls of a steel building in San Patricio, in the Hondo Valley, around a roll-up door, plumbing lines and a small room.
Guides
Send photos, the size and eave height, and what happens inside, whether it’s cows, trucks, or a home shop, and we’ll arrange a site visit or review your plans before preparing a written estimate.
