Schedule a Visit
Main Street in downtown Roswell, New Mexico, with traffic and US 285, 70 and 380 route signs

Photo: Phil Campbell, CC BY 2.0 (cropped)

Concrete Leveling in Roswell with Foam Injection

A sunken driveway, sidewalk, stoop, or shop floor brought back up flush with polyurethane foam pumped through a few small holes. For homes and farms in Roswell and down the valley to Dexter, Hagerman, and Lake Arthur.

Schedule a Visit

Concrete Lifting & Leveling in Roswell

Roswell concrete lifting starts with where storm water sits

Much of Roswell’s rain arrives in hard summer thunderstorms, and the town sits on nearly level ground in the Pecos Valley. So water doesn’t hurry off a lot. It pools along the edge of a driveway, runs into the joints of a walk, and soaks the dirt underneath. A shop or carport roof with no gutters, a swamp cooler drain, or a sprinkler that hits the sidewalk keeps one spot wet long after the storm. Wet fill packs down or washes away, and that side of the slab drops. The dip then holds the next storm’s water, so a small drop tends to grow.

Age plays a part as well. Plenty of walks and driveways here were poured while Walker Air Force Base was still open, and many have a newer slab added on, like a widened driveway or back patio, often poured over fill that wasn’t packed as well. Concrete leveling raises what is still in one piece. Polyurethane foam goes in through a few small drilled holes, swells to fill the space, and raises the slab; then the holes get patched. The same foam fills hollow spots where dirt washed out, and it is light and cures in minutes. We also point out where the water is getting in before any lifting starts. Concrete that has crumbled into small pieces needs replacing, and we’ll say so.

Typical concrete leveling jobs in Roswell

  • Driveway corners that dropped where monsoon rain puddles after every storm
  • Street-side sidewalk panels that sank and left a trip edge
  • Front stoops and steps tipping away from older brick houses
  • Widened driveways and add-on patios dropping at the seam
  • Floors and door slabs in farm shops near Dexter and Hagerman

What we plan around in Roswell

  • Level ground that lets summer storm water pond against slabs
  • Gutterless steel roofs on shops and carports shedding water in a line
  • Swamp cooler drains and sprinklers soaking the same spot for months
  • Decades-old concrete that we check for crumbling before any lift

How it works

  1. Step 1

    Find the cause

    We look at the slab, how far it dropped, and where the water that softened the ground came from.

  2. Step 2

    Drill

    A few dime-sized holes go through the slab. No saw cuts and no jackhammer.

  3. Step 3

    Lift

    Polyurethane foam goes in under the slab and expands, and we watch the concrete come up as it does.

  4. Step 4

    Patch

    The holes get patched and the area cleaned up. The crew confirms when foot traffic and vehicles can return.

Also serving: Midway, Dexter, Hagerman, Lake Arthur.

Guides

Worth reading before you call

All guides

Concrete lifting guide

How polyurethane concrete lifting works, from drill to patch

A sunken driveway panel or a patio tipping toward the house can often be raised with foam. Here is how the job goes, how the rise is controlled, and where lifting stops being the answer.

5 min read

Slab support guide

Voids under concrete: signs, causes and fixes

A slab can ride over empty ground for years before it cracks. Here is how to spot a hollow from above, what opens one up in New Mexico soil, and which fix it needs.

5 min read

Concrete lifting guide

Why driveways sink at the garage, and how a lift fixes it

The panel in front of the garage drops more often than any other concrete around a house. Here is what is going on under it, what the lip at the door is telling you, and how a lift brings it back.

5 min read

Concrete Lifting & Leveling in Roswell: common questions

Both. A sidewalk panel that sank lifts the same way a driveway does: foam goes in under the low section and brings its edge up flush with the next one, so the joint stops catching feet. The panel has to be in one piece. If the lip is there because a root pushed the other panel up, foam can’t lower that one, and it may need grinding or replacing.
It can, if the water that dropped it keeps coming. Lifting raises the slab and fills the gap under it, but it doesn’t stop the ground below from settling further when storm water keeps soaking in at the same spot. On Roswell’s level lots the fix is often small: a gutter or downspout extension, a cooler drain moved, a sprinkler head turned, or dirt graded so water runs away from the concrete.
A few patched holes, each about the size of a dime, spread across the slab where the foam went in. The patches sit flush, but on weathered concrete they usually show a little if you look for them. There’s no digging and no broken concrete to haul off, and the crew confirms when the slab can be walked or driven on.

Need concrete leveling in Roswell?

Lay a tape measure at the low edge, send us a photo and the address, and we’ll set up a site visit.

Schedule a VisitSend PlansCall (855) 575-3626